POWDER COATING AND METAL POLISHING SERVICES
2108 White Pine Drive
SAYLORSBURG, PA 18353
ph: 570-856-4951
dave
All parts are thoroughly degreased to ensure the best quality powder coated part.
Items that have been previously painted or powder coated are submerged in a liquid stripping solution that chemically softens or liquifies the paint or powder finish without harming the item itself.
Items are media blasted to remove rust, corrosion and old paint. This step provides the item to be coated with a clean and mild rough surface for the best powder adhesion.
This step mostly applies to cast parts, automotive engine parts, or any item that was origionally in contact with oil, grease, fuel, etc..
Items are placed in an oven and baked at a high temperature resulting in the burn off or out gassing of any left over grease or oils imbedded in the part.
These are the final preparation steps before Powdercoating. After parts are out gassed they are cleaned again to remove any dirt and/or oils that were burned off in the previous step. If needed the parts are sprayed with a iron phosphate to ensure proper adhesion and corrosion resistance. This is the time that any threaded bolt holes or studs are plugged or covered and any masking needed is done.
Finally the item is coated with powder and cured in an oven at a specific temperature for a specific period of time.
On this page you will find a list of our provided services. Each step of the powder coating process has been broken down individually.
It is not always necessary to perform each of these steps when powder coating an item. Each item is inspected individually for what process is needed to ensure the best final finish and durability. Decisions of this process are based on item type(steel,aluminum), age, condition, and previous use of the item.
Pricing is based on the same aspects and treated individually. For example the cost of stripping and coating an old rusty wheel will generally cost more than stripping and coating the same wheel in new condition.
Color samples are available upon request. Over 500 color swatches in stock and thousands of colors/textures available. Special order powders not normally in stock require a deposit.
At this time we are able to handle parts up to 5ft long, 4ft high and 3ft wide. As our company continues to grow so will our size capabilities.
Copyright 2011 Renewed Finishes. All rights reserved.
2108 White Pine Drive
SAYLORSBURG, PA 18353
ph: 570-856-4951
dave